Maxtech XT5861 Bedienungsanleitung PDF herunterladen (Seite 5)

• Plug the 15-pin male connector on the video cable into the output

connector on the rear of your computer system. The video output

connector on your computer may be either in a location similar to

Figure 2-2

or on an expansion board. Secure the cable to the

computer using the thumbscrews on the 15-pin connector.

• Attach the power cord to the monitor and plug it into an AC outlet.

• The monitor is now ready for use.

Section 3 - Monitor Controls and LEDs

1. Power Indicators: LEDs A and B indicate the state of the Monitor.

• LED A On (green) Normal operations.

• LED A flashing DPMS (Display Power Management Signaling)

“STAND-BY” mode.

• LED B On (orange) DPMS “OFF” mode.

2. Power Switch: Push to turn the monitor ON, push again to turn the

monitor OFF.

3. Trapezoid: Adjusts the angle of the sides of the display to make the

display rectangular.

4. Pincushion: Adjusts the curvature of the sides of the display to make

the sides straight.

5. Vertical-Position: Adjusts the vertical position

34 5 67 1098

Figure 3-1 Controls and LEDs

1 2 3 4 5 6 7 8 9 10

Keine Kommentare

Maxtech XT5861 Bedienungsanleitung Seite 5